The toggle plate of the jaw crusher is a cast iron piece that has passed accurate accounting. It is not only a force transmission component, but also a safety part of the jaw crusher.The toggle plate will be broken immediately and the crusher will stop working to prevent damage to the entire machine When the unbreakable material falls into the crusher and the machine exceeds the normal load.
1. Introduction
The toggle plate and toggle plate pad use rolling contact method, and there is little friction under normal use. Only a layer of grease is applied to the contact surface. The whole part is used to adjust the size of the discharge port and compensate the wear between the jaw plate, the toggle plate and the toggle pad.
2. Installation steps
The toggle plate of the jaw crusher is both a safety part and a vulnerable part. It is easy to damage. It should be replaced immediately once the toggle plate is worn or broken. How to replace the toggle plate after it is worn? The following are the installation steps of the jaw crusher toggle plate:
a. To install the toggle plate of the jaw crusher, first loosen the spring nut of the tension rod, and then remove the spring.
b. Use a chain and steel wire to tie the lower part of the movable jaw.
c. Use a professional installation tool to pull the wire with a hand hoist to make the movable jaw close to the fixed plate, and the toggle plate will automatically fall.
d. Use a wire to pull the new bracket into the bracket seat after the old bracket is removed.
e. Then, relax the hand hoist so that the toggle plate and the toggle plate seat are in close contact.
f. Finally, install the pull rod and the spring and the toggle plate is supported in the toggle plate seat, and the hand hoist can be removed.
The above are the installation steps of the jaw crusher toggle plate. The correct installation can reduce the impact of the normal operation of the crushing equipment due to improper installation in the future work, which can also save the time of the jaw crusher for maintenance.
3. Role
a Transmission power
sometimes the power transmitted is greater than the crushing force.
b Plays the role of insurance
The toggle plate breaks first when the crushing cavity falls into non-crushing materials (such as drill rods, broken shovel teeth), so as to protect other parts of the machine from damage.
c Adjust the size of the discharge opening
Some simple toggle jaw crushers adjust the size of the discharge opening by changing the toggle plate of different lengths.
4. Structure
According to the structure, the toggle plate is divided into two types: assembly type and integral type: the toggle plate used in the simple pendulum jaw crusher is an assembled structure. It is assembled by connecting a toggle body and two toggle heads, so that only the toggle heads that are easily worn out can be replaced to save consumable metal. Since the bracket used in the large-scale crusher is heavier, lifting rings should be designed for this bracket. The integral toggle plate is used on the compound pendulum jaw crusher because its weight and size are relatively small.
